PROSOFT MVI56-GEC 通用串行
维修工具软件位于MVI56-GEC（个人电脑）上，并通过驱动程序的9针维修端口与ProAct驱动程序通信。各种用户可使用以下模式：出厂校准、测试、配置、用户校准、调整和监控模式（见下图的操作模式）。工厂校准和测试模式是Woodward内部独有的选项；客户可以使用其他所有功能。维修工具模式受密码保护，以防止无意中更改程序。MVI56-GEC功能始终可用，不受密码保护。为了安全起见，只有在机组关闭时才能进入密码保护模式。可以通过维修工具命令或打开低功率待机模式离散输入来关闭机组。
连接到模块的网页如果您的网络配置为使用MVI56-GEC范围内的IP地址，请打开MVI56-GEC（版本7或更高版本），然后连接到以下地址：MVI56-GEC如果您的网络配置为使用不同的IP范围，请执行以下步骤：1断开电脑与网络的连接2连接电脑上的以太网端口和模块上的端口1之间的以太网电缆3临时更改电脑上的IP地址和子网掩码以匹配模块上的网络配置：IP地址：MVI56-GEC子网掩码：MVI56-GEC重要提示：记下您的IP地址设置。在重新连接到网络之前，您需要恢复这些设置。
Connect to the module's web page again at the module's new IP address. The following table describes the default Ethernet port configuration and login information. Factory Default settings Ethernet Ports: Port 1 Port 2 IP: 192.168.1.254. DHCP User Name: admin Password: admin Important: The User Name and Password are case-sensitive. 1.8 Logging In You can view the status and configuration of the MVI56-GEC without logging in. However, to modify the module's configuration, or to perform maintenance tasks, you must log in. The LOGIN and LOGOUT buttons are located in the status bar at the bottom of the module's web page. To Log In Click the LOGIN button on the status bar at the bottom of the page.The module has two RJ45 Ethernet ports, located at the bottom of the front panel on the module.
Open Microsoft Internet Explorer (version 7, or higher) and connect to the following address:MVI56-GEC Click the LOGIN button at the bottom of the screen, and use the following username and password to login. Username: admin Password: admin 6 Click the MVI56-GECtab, and then the MVI56-GECtab. Configure the IP Address, Subnet Mask, and Default Gateway to work with your network. 7 Click the SAVE button to apply the updated settings 8 Change the IP Address and Subnet Mask settings on your PC back to their original values, and then reconnect your PC to the network.
Connect to the Module's Web Page If your network is configured to use IP addresses in the rangeMVI56-GEC, open Microsoft Internet Explorer (version 7, or higher), and connect to the following address: MVI56-GECIf your network is configured to use a different IP range, follow these steps: 1 Disconnect your PC from the network 2 Connect the Ethernet cable between the Ethernet port on your PC and Port 1 on the module 3 Temporarily change the IP address and Subnet Mask on your PC to match the network configuration on the module: IP address: MVI56-GEC Subnet mask: MVI56-GEC Important: Make a note of your IP Address settings. You will need to restore these settings before you reconnect to the network.